Installation, configuration, manipulations et préparation de pièce avec Ultimaker Cura.
Version utilisée : Ultimaker Cura 4.3.0
Course Content
Installer Cura et paramétrer son imprimante 3D [32:25]
You don't currently have access to this content
L’interface et les options [19:21]
You don't currently have access to this content
Manipulation des pièces et prévisualisation de la découpe [14:42]
You don't currently have access to this content
Quelques plugins utiles [11:48]
You don't currently have access to this content
Les paramètres importants d’impression 3D [27:54]
You don't currently have access to this content
Start-Gcode et End-Gcode [32:45]
You don't currently have access to this content
Étude #1 – Cura : Positionnement, Orientation, Supports [24:34]
You don't currently have access to this content
Étude #2 – Cura : Cube de calibration et ajustement des cotes [20:34]
You don't currently have access to this content
